I picked up a 3lb vacuum pack of beef riblets because I wanted beef but not a steak. I also didn’t want to have to wait as long as something like a brisket or shoulder would take to smoke.
I started with the rub. I wanted one with no sugar as that doesn’t taste as good on beef as it does on pork. For brisket, I usually use a dalmatian rub of equal parts salt and black pepper but I wanted to put some additional flavor on the ribs. Once I put together granulated garlic and onion and some paprika, it needed a little something morish, so I added dry mustard. Excellent! You could put in some cayenne but the ribs I’m using are thin and I don’t want too much heat.
I cooked them in my Weber kettle grill over indirect with chunks of hickory wood for the smoke. Remember to give yourself plenty of time – smoking time on the grill was three hours but you need to add another hour of rest.
Definitely use a meat thermometer to check the internal temp but you know they’re getting near done when the meat has pulled away from the ends of the bone.
This is what you’re looking for – nice color, they crack a little at the bend and there is at least a finger width of bone showing. If you’ll be patient for just a little longer, you’ll have tender, juicy meat with a lovely flavor from the rub and the smoke.
After the long rest, they were very good and toothsome! Luckily no one else was around to see me eat the whole thing.
Smoking Beef Ribs on the Grill
¼ cup kosher salt
¼ cup black pepper
1 tablespoons garlic powder
1 tablespoons onion powder
1 tablespoons paprika
1 tablespoon dry mustard
3 lb rack of beef ribs
Combine the rub ingredients in a bowl and mix well.
Rinse the meat and pat dry. Remove the silver skin from the ribs. Loosen with a dull knife and use a paper towel to pull the membrane off. Coat both sides of the beef with the rub and set in the refrigerator for at least an hour. Store any unused rub in an airtight container.
Remove the meat from fridge and set on counter while the grill is prepped.
Prepare the grill for indirect cooking and to last 3 hours. I do this by putting a ring of unlit coals around my Weber kettle grill, making sure all the briquettes are touching each other. I fill a chimney with charcoal and, once the coals become ashy, I spread them on two sides of the grill, layered on top of some unlit coals. This way, they light the coals beneath them and slowly ignite the rest so the grill should maintain 225-250 degrees F for at least three hours.
Put a drip pan in the center of the grill and add water to the pan. This will keep things moist while the magic happens. Place the rack of ribs bone side down in the center of the grill. Add dampened hickory chunks to the fire to smoke. Let the ribs cook until they reach an internal temperature of 200-205 degrees F. Carry over temperature will bring them to 210, which is ideal for beef ribs. Take ribs off the heat and tent with aluminum foil. Let ribs rest for at least an hour before eating. If it will be longer than an hour before eating, place the ribs in a cooler lined with towels.
You can cheat once the meat reaches an internal temperature of 170 degrees and wrap them in aluminum foil or butcher’s paper and let them finish cooking in an oven at 235 degrees F. While keeping them uncovered on the grill will allow for the best bark, I totally understand using the Texas crutch (and I have done so plenty of times myself).
While I don’t tend to use bbq sauce, the time to do so is when you wrap the ribs or for the final hour of cooking. Give them a generous baste and it will allow for another layer of flavor. Try my coca-cola bbq sauce. I avoid commercial sauces as they have a lot of sugar which can burn and add a bitter taste.